Sorry guys, I am new using the rotary plasma module.
Question: When I do the simulation for the cutting of a round pipe, I see what it looks like the torch horizontally on the side (3 oclock) and not vertically at 12 oclock. And I think I might have the axis system rotated. Is there a different way in Sheetcam of placing a cut an "X" distance from the start of a pipe, other than JOB OPTIONS=>ORIGIN=>ENTER COORDINATES. Could I locate the "X" distance in the DXF file?
Could you please help me straight out these issues?
Sorry guys, I am new using the rotary plasma module.
Question: When I do the simulation for the cutting of a round pipe, I see what it looks like the torch horizontally on the side (3 oclock) and not vertically at 12 oclock. And I think I might have the axis system rotated. Is there a different way in Sheetcam of placing a cut an "X" distance from the start of a pipe, other than JOB OPTIONS=>ORIGIN=>ENTER COORDINATES. Could I locate the "X" distance in the DXF file?
Could you please help me straight out these issues?
Sorry guys, I am new using the rotary plasma module.
Question: When I do the simulation for the cutting of a round pipe, I see what it looks like the torch horizontally on the side (3 oclock) and not vertically at 12 oclock. And I think I might have the axis system rotated. Is there a different way in Sheetcam of placing a cut an "X" distance from the start of a pipe, other than JOB OPTIONS=>ORIGIN=>ENTER COORDINATES. Could I locate the "X" distance in the DXF file?
Could you please help me straight out these issues?