Partial and Empty GCode at Post

InnovativeMetals · Post by **InnovativeMetals** » Fri Oct 31, 2014 12:59 pm

Yesterday I lost the ability to Post code on my laptop and my shop PC.

The laptop SCam works great until you Post. The code has file name, date, homing position, and off. It never even processed the cut paths.

The shop PC is similar, but it does process a partial code. It also gives me an error when closing SCam.

I have tried reinstalling both the program and the license. SCam is fully updated on the laptop. This was out of the blue, and I am at a loss.

Here is what the gcode looks like:

N0010 (Filename: Fishing_Hole.tap)
N0020 (Post processor: MP1000-THC - SCRIBER.scpost)
N0030 (Date: 31/10/2014)
N0040 G20 (Units: Inches)
N0050 G53 G90 G40
N0060 F1
N0070 (Part: Fishing_Hole)
N0080 G00 X0.0000 Y0.0000 Z0.7500
N0090 M05 M30

Thanks for the help!

ArchieF · Post by **ArchieF** » Sat Nov 01, 2014 8:38 am

Looks to me like no operation defined or active

Richard

Post by **Les Newell** » Sat Nov 01, 2014 9:52 am

We are sorting this out off-list but it appears to be a problem with the license.

InnovativeMetals · Post by **InnovativeMetals** » Sun Nov 02, 2014 7:48 pm

Thanks for taking a look ArchieF.