Is it Corel draw or Sheet cam?
Is it Corel draw or Sheet cam?
Hi I keep having a problem.I have Corel draw x3 and some times when I run a file from there into SC it will show open lines and over lapping lines in SC when no problem shows up in CD no matter how close I zoom.Any body have some ideas?
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
Is it Corel draw or Sheet cam?
That could be a start but I don't know how to do that.Thanks
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm
Is it Corel draw or Sheet cam?
Thanks Les that works now Allan.
Les I've had the same problem since we switched computers. I make a file in cd and run it through dxf standard tool. When I open that file in sheetcam there are a lot of broken lines and extra lines when it comes to a sharp turn. It seems to work all right on simple files, but on more complicated files it's all messed up. Hope you can help. Thanks,,,,,,,,Curly
- Les Newell
- Site Admin
- Posts: 3675
- Joined: Thu May 11, 2006 8:12 pm