sheetcam.com Forum Index sheetcam.com
SheetCam discussion board
 
 Forum SubscriptionsForum Subscriptions    FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Re: Tips needed

 
Post new topic   Reply to topic    sheetcam.com Forum Index -> Yahoo posts (yahoo @forum.sheetcam.com)
View previous topic :: View next topic  
Author Message
wcottr
Guest
PostPosted: Mon Aug 31, 2009 3:49 am    Post subject: Re: Tips needed Reply with quote
I am using TNG Les - but still call it plain ol Sheetcam. I tried it again using the mouse this AM w/o success so used coordinates per your suggestion and that worked for me. That had not occured to me - duh.

Bill

--- In sheetcam@yahoogroups.com, Leslie Newell <les.newell@...> wrote:
Quote:

This is a problem in SheetCam standard. TNG handles it a lot better. A
workaround is to enter the new position for the part in the boxes at the
bottom of the screen.

Les




wcottr wrote:
Quote:
Sometimes I put a single line into Sheetcam to make test cuts with my plasma when using a new material. I have a problem picking up a single line to move it around on the sheet. My mouse just will not seem to grab it for movement. There has to be a better way and I need suggestions on how to pick up a single line.





------------------------------------
Back to top
Display posts from previous:   
Post new topic   Reply to topic    sheetcam.com Forum Index -> Yahoo posts (yahoo @forum.sheetcam.com) All times are GMT
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
You can attach files in this forum
You can download files in this forum


Powered by phpBB © 2001, 2005 phpBB Group