sheetcam.com

Hi Les,
That was it: shape wasn't closed!
Thanks a lot and best regards.
Heiner

Hi,
everything is going well but sheetcam doesn´t cut the marked opening WITH INSIDE CONTOUR at all.
What is to do?
Thanks and best regards
Heiner

Super!
I´ll enjoy it!
Regards
4Heiner

Hi,
sometimes it could be very useful to mark more than one tab to be deleted.
E.g. when marking horizontal (or vertical) there are perhaps 3/4/5 superfluous tabs I don´t want. How to mark them at once do be deleted at the same time?
Thanks and best regards
4Heiner

Of course!
Thanks a lot.
Regards
4heiner

You are still getting 1s in the tap file? Are you sure you are using the correct post processor? I did it once again: I changed the postprocessor as you suggested: ... if (endZ < safeZ) then post.Text (" G4 P1\0.5") endZ = safeZ OnRapid() end ... I elected the modified Postprocessor "...

Les Newell wrote:Are you getting an error or is it just ignoring the dwell.? It could be that your control simply does not understand very short dwells. What control are you using?

Its just ignoring the dwell (always 1 sec). This is to be seen in the *.tap file.
I use Mach3 as control.

His Les,
the hint using the dwelling time was very usefull. But it seems that e.g. one second is to long. I tried it with half and a quarter of a second and typed 0.5 and 0.25. But that wouldn´t go. So how has the input to be done?
Thanks for answer an best regards
4Heiner

Hi,
it works! Thank you so much!
I saved the modified processor under a special name for I suppose that it now will insert the G4 advice every time, which may not be desired.
So again thanks for the tip and best regards
4Heiner

Hi Les, I modified the file as you told me. Then I loaded the “new” scpost-file (machine > postprocessor > import postp.) The result is as following: ….. N0080 S6000 M01 N0090 G00 Z5.0000 N0100 X0.0000 Y0.0000 N0110 (Bohrer, 1 mm Durchmesser) N0120 T22 M06 G43 H22 N0130 G00 Z3.0000 N0140 S6000 M03 N...

Hi Les, thanks for the hints. "Just out of interest why do you want to do this?" I´m manufacturing rivets on a water tank for a model-loco. At first holes with 0.2mm are drilled and then the rivets are stamped by an special grounded (broken) drill. The rivets are better when the drill rema...

Hi, I would like to have the drill remaining in the hole for e.g. 1sec after having done the work. But I don´t know how to do it in sheetCAM TNG. I have completed by hand the following example with line 0161 and 0191 to demonstrate what I mean. N0120 T22 M06 G43 H22 N0130 G00 Z3.0000 N0140 S6000 M03...

Thank you. That´s it!
Regards
4Heiner

Hi,
o.k. that´s right, but actually is V 4.0.4 to be downloaded without German language. And the version of Chr. Selig is V 4.0.1. Is it then possible to add the file "de" from the folder "languages" into V 4.0.4?
Thanks and best regards
4heiner

Hi,
in the precent Version I had the opportunity to switch over to German. I miss it in V 4.0.4. Can anyone help me?
Thanks and best regards
4heiner