sheetcam.com

Hello Everyone, Just FYI a lot of you seem to be having the same problem that I am, after post processing then you load tap file into Mach 3 and low and behold, there is no G-code. During my research I have found this is usually due to the License file. the problem seems to be that we bought a table...

The way I did mine ( which is probably wrong since I'm self taught ) was to run "no" offset 6" test cuts then used a digital caliper to measure the the width of the cut near the center of the cut, then divide by 2.



But if I were you, I'd listen to Les and do it like he says