sheetcam.com

Hi there,
I am already using the development version of Sheetcam (with a proper licence). The problem appears only with the specific dxf file. If I remove some parts from the file then it works fine.
Any other suggestions?
Thanks in advance for your time

Hi there,
everytime I am trying to import the specfific drawing once I am trying to create a new jet cutting operation, sheetcam crashes and shuts down!
Anyone has any idea what am I doing wrong?
Thanks in advance

In big arcs I didn't have any problem. Only in very small arcs.
Big arcs were being done corectly without your "smart"suggestion.

Yoou were right!
The loop sharp corners suggestion worked just fine.
However I still don't get it why this happens? Should I use by default your suggestion in order to avoid this kind of side effects?

I checked with the simulation tool of sheetcam and it seems OK. I also checked the code line by line and especially at the points where the problem appears, and it seems to me just fine. I figured out that the problem appears in corners where the torch does a small arc path in order to cut properly....

I checked it and I have it in "none". The problem is that it does it usually on corners of more than ~120deg and except from the fact that the torch collides because of the small hole that meshes up the arc height control, the circular loop is always on the opposite direction (the torch in...

Hi guys, using the Sheetcam I figured that when it cuts some dull angles of the workpiece, it does something like a cut routine by making a small circle. The problem is that this small circle is so small that meshes up the voltage control and makes the torch diving and colliding on the workpiece. An...

Les the code snippets work just fine. Off course they require some fine tunning, by playing with the distances.
But after some trials it works just fine
Thank you very much, it is much appreciated

Sorry for being such a pain, but unfortunately I cannot understand how to import the two code snippets in the default rule set.
Can you please help a llittle bit more
Thank you in advance

Should I type something or you have file to load?

The problem appears exactly where you said (lead in-out).
And it appears in every drwaing I tried, nomatter if it is a hole or a complete part.
I am sending you a simple drawing, just to check

Hi Les, thank you very much about the post processor. It is working in realtive coordinates ans the there is no problem about the comments. My problem now is that once it cuts the part (just 1 mm before ending the operation) the torch goes down and colides with the sheet. It does it when I am doing ...

Continued

This is the list with the auxiliar function my machine uses. The ones in pencil circle are the functions that are used mainly.
Thanks a lot again

I will scan the code's list from the programming manual and I will send them as attachement, is just 3, 4 pages.
Tnaks again