sheetcam.com

Just wondering if the sheetcam@yahoogroups.com are no longer active and not getting through to the group.

I notice a forum upgrade message above but not sure if that effects posts via yahoo?

Adrian

OK I have bitten the bullet and undertaken a new Opensuse install
everything from scratch

Installed Sheetcam again and it all seems to work.

Just got to get it all backj in there now.

Thanks for the help
Cheers

Adrian

No the graphics are in built on the Motherboards.

Its a Dell Optiplex760 Duel core PC the specs say
Integrated Intel® Graphics Media Accelerator 4500.

Not much of a wiz on computers so I will have a play checking drivers.

Adrian

I have tried re-installing various other linux packages such as Lua and anything that has Chunk., no joy. As a last resort I have just run the de install script, the removed all directories, reboot and then install fresh. on first run it asked for language selected system it asks to agree license th...

Additional information 07:34:12: Application started 07:34:12: System language is English (en_GB) 07:34:12: Currently selected language is en_GB 07:34:12: Currently using English (en_GB) 07:34:13: Lua: Error while running chunk attempt to call a string value stack traceback: 07:34:13: Loading /home/...

Hello, hope someone can help? Running 6.1.6 64 bit linux install on opensuse13.2. All going well until my motherboard failed. Picked up another very similar PC and could literally just place the old hard drive in the new machine and boot up with only a change to the network card settings. My version...

OK just had some success I think in getting Z to rapid height first. part of the post processor now reads:- function OnRapid() ---text(currentx," ",currenty," ",endx," ",endy) if (math.hypot(endX - currentX, endY - current...

It may be because I am running in Linux or I have missed a setting somewhere but when I press the button for Post documentation, nothing happens. My main concern looking at some G-code it has produced is that Pen down works OK, but on Pen up and then going on to rapid move I would have expected Z to...

Hello Art I am replying to this via email as I have not got the ack from the forum yet to say I am on board I am just looking at the Minimum G-code post processor I need to change a few things. The new controller I am using is another Chinese 3 axis 3.5 amp device and i have to turn it on and off. I...